PCled-chassis 6-pins ultrastille DC 12V computer RGB-verlichting 12025 ventilator luchtgekoelde desktop host koeler CF

Product Name: Cooling RGB Fan Size: 120x120x25mm Speed: 650-1800RPM ± 10% Air volume: 47.2CFM ± 10% Wind pressure: 1.60mmH2O ± 10% Noise: 6-30dBA MTTF: 50000 hours Fan bearings: hydraulic Fan interface: 6 Pin Rated voltage of lighting: 5V DC Rated current of lighting: 1.4A Rated voltage of fan: 12V DC Fan rated current: 0.25A ± 10% Line length: approximately 50CM Kind reminder: The product needs to be used with a controller. The parameters are subject to actual parameters and are subject to change without prior notice The following is an introduction to the functions of the remote control buttons 1 represents power on/motherboard switching 2 represents fan speed+ 3 represents fan speed- 4 represents mode+ 5 represents mode- 6 represents continuous pressing for 10 times to enter RGB sequence adjustment. Press the red key until it appears red, then press the green key until it appears green, and then press the off 7 represents static color key 8 represents static brightness- 9 represents static brightness+ 10 represents off 11 represents automatic mode cycle The following figure shows the installation method of the cooling fan 1 represents the front of the cooling fan, and the front is the air inlet 2 represents the back of the cooling fan and the back is the air outlet 3 represents placing the fan inside the chassis. The front of the fan (air inlet) should face the inside of the chassis, and the back of the fan (air outlet) should face the outside of the chassis 4 represents the screws provided. Align the fan with the holes on the panel and tighten it firmly The following figure shows the interface connection between the power position of the host chassis and the controller 1 represents the power position of the host chassis 2 represents finding the IDE (Big 4P) interface as shown in the figure 3 represents the interface to be connected in series 4 represents the connection between the power interface of the host chassis and the interface of the controller The figure below shows the manual remote control of thecontroller. Remove the sticker before using the remote control The following figure shows the size of the fan, with a length of 120mm and a height of 25mm, with a hole spacing of 105mm The following diagram shows the product display during nighttime live shooting The following diagram shows the effect of 10 RGB fans installed in a chassis and controller during actual shooting